Spray Scanner

Specificaties

• Measuring surface of 80 x 150 cm.
• The measuring plane is horizontal (no slope in the upper surface) - max 99 m.
• Unique in its measuring principle (electronic conductivity). Electrodes measure the rate at which the spray liquid is collected by each of the patternator channels. These values are retained by the memory box to collectively derive the degree of uniformity as a Coefficient of Variation (CV%).
• Display unit: calibration and test procedure is very comprehensible with clear instructions given by the display unit – all necessary parameters such as starting position and boom width, being readily entered by the operator.
• The data are stored in a memory box and can be transferred to a PC.
• The data in the memory box can be exchanged through a wireless communication system between scanner and PC, which allows a continuous updating of results on the computer and steering of the device from the PC.
• With the software, a complete inspection report can be generated and printed, or only report and export the data and graph of the measured distribution.
• The kit inlcudes 9 rail parts of 3.20 m length. Additional rails can be ordered if required.
• In order to collect and/or retrieve liquids, a range of waste water collectors can be supplied.
• Navigation through the display unit or from the pc.
• Partial measuring of the spray boom is possible.
• An extension for measuring high speed nozzles (from 1.50 m up to 2.10 m) can be supplied.
• Training is included to explain the use and maintenance of the scanner (+/- 4 hours).
• Thoroughly tested and fully approved by the JKI (number G1281) and ÖAIP.